26
EN
!
Dispose of used safety cartridges that
are no longer required for the current
application (see chapter “Disposal of
equipment” on page
31).
!
The safety cartridges are supplied
in sterile packaging. Do not remove
them from their packaging until
immediately before you intend to use
them.
!
Always place the SOL Nova safely
so that the safety cartridge does
not come into contact with other
surfaces.
!
Seek medical attention if injured by
a
contaminated needle.
!
Switch o
ff
the power supply to the
SOL
Nova.
!
Insert
the
safety
cartridge
in
the
opening in the handle, as illustrated
below.
Due to its locating points on the top and
bottom, each safety cartridge can only
fit in the oval opening in two ways.
!
Rotate the safety cartridge clockwise
through approx. 45°.
As you rotate it, several locating points
will engage audibly until the safety car-
tridge is firmly locked into position.
!
Check that the safety cartridge is firmly
seated.
!
To remove the safety cartridge, turn it
anti-clockwise and remove it from the
handle.
5.3
Connecting the power unit
CAUTION
Risk of short circuits
If cable or cable connection is visibly
damaged, there is a risk of damage to
the electronics.
!
Perform a visual inspection of the
SOL Nova and the cable for signs of
damage, e.g. a defective cable con-
nection.
!
Never bend the connecting cable
while in operation.
!
Observe the operating instructions
for the particular power unit.
CAUTION
Cables constitute a trip hazard
People can stumble over inappropri-
ately routed cables and get injured.
!
Route all cables so that no-one can
stumble over them or pull them ac-
cidentally.
ca. 45°
Cheyenne SOL Nova
