Chevrolet Impala Police 2012, Manual

Page: 55 / 62

Black plate (23,1)
Chevrolet Impala Police Package - 2012
Special Equipment Options 15-23
Option 6F5 is a universal wiring
harness for roof-mounted
equipment. The harness is routed
from a 1.5 m (5 ft) coil of wire in
the passenger side footwell to a
connector on the passenger side of
the trunk.
When the SEO 6B7 (center hole) is
ordered, two color-coded 5.0 mm²
(10 gauge) wires extend 60 cm
(24 in) through a grommet
approximately 74 cm (30 in) behind
the top of the windshield at the
center of the roof.
When SEO 6J5 (passenger side
hole) is ordered, two color
‐ coded
5.0 mm² (10 ‐ gauge) wires extend
60 cm (24 in) through a grommet
approximately 74 cm (30 in) behind
the top of the windshield and 15 cm
(6 in) inboard from the passenger
side longitudinal roof joint.
Wiring Provisions Front
Speakers - SEO WX7
About 165 cm (65 in) of auxiliary
speaker wire is run from the
instrument panel radio connector
and is coiled under the center of
the instrument panel. The wiring
permits the connection of front door
speakers to customer-installed
communication equipment.
Radio outputs from the front
speakers are sent to the rear
speakers to maintain the required
open door/key in the ignition
reminder chime.
Electrical Connections
1. Disconnect the negative ( − )
battery cable at the battery.
2. Remove the tape from the wire
coiled under the instrument
panel to uncoil it.
3. Using proper electrical
connectors, connect the wires
for the left front audio output
of the customer-installed
communication device. The left
front positive wire is tan and the
left front negative wire is gray.