Page 1 of 2
Figure 1 - BMT-75PC shown with BDH-7500 Housing
INSTALLATION MANUAL – BMT-75PC
Pendant Cap Mounting Accessory for BDH-7500
WARNING: Before beginning installation of this product, carefully review
the safeguards and precautions found on page 2 of this manual.
Unpacking
Unpack carefully. This is mechanical equipment and should
be handled with care. If an item appears to have been
damaged in shipment, replace it properly in its carton and
notify the shipper. If any items are missing, notify the
shipper. The shipping carton is the safest container in which
the unit may be transported. Save it for possible future use.
Service
If the unit ever needs repair service, the customer should
contact Chesapeake & Midlantic Marketing for a return
materials authorization (RMA) and shipping instructions.
Care and Maintenance
Perform routine maintenance to keep the unit dust free.
Model Designation
BMT-75PC
PENDANT CAP FOR BDH-7500
Description
The BMT-75PC accessory enables the BDH-7500 housing to
be attached to a pole with 1.5” NPT threads. The mount is
constructed of powder coated aluminum with stainless steel
fasteners.
Hardware Kit
4 x Lock Nut, ¼-20
4 x Washer, ¼” Rubber Bonded
Tools Required
7/16” Socket and Driver
Teflon Pipe Thread Sealant Tape
Certification
Installation should be performed by a licensed professional
and conform to the National Electrical Code (NEC) and any
applicable local codes.
Installation
1.
Remove unit from packaging.
2.
Prepare pipe with 1.5” NPT threads.
3.
Run network cable to installation site leaving enough
slack at the end of the pole to allow cable entry through
the housing to the camera.
4.
Apply Teflon thread sealant to the pipe threads.
5.
Attach BMT-75PC to the pole.
6.
Prepare BDH-7500 housing per instructions included with
the unit treating BMT-75PC as the installation surface.
7.
Attach housing to pendant cap using the rubber washers
and ¼-20 nuts from the kit. Ensure the rubber side of
the washer faces the base.
