Chery QQ, Service Manual

Page: 282 / 635

Chery QQ Service Manual Chassis System
Chery Automobile Co., Ltd
86
Steps for installation:
1.Do the installation by referring
to the dismounting steps.
2.Points of attention:
①
In the screw tightening process, the fastening
bolts controlled by corner tightening
submission limits should be replaced after each
action of loosening.
.
②
The screws should be tightened to the
specified torques after the installation.
III. Spiral spring and dampener
(supporting column)
（
I
）
Before removing the supporting column,
check the performances of the supporting
column
Check and adjust the tire air pressure as specified;
push sidewise and shake the front part of the car
for 3—4 times with equal forces applied to each
pushing. When the action of pushing and
bouncing back takes place, pay attention to the
resistance of the supporting column and the
frequencies of the back bouncing of the car body.
Compare the resistances as well as the
frequencies of bounces for the columns
(dampeners) on the left and right sides, which
should be identical. If the supporting column
(dampener) works normally, the car will stop
immediately as soon as the hand-push forces are
released or after the back bounces for 1—2 times.
（
II
）
Removal and installation of the front
absorber assembly
Removal
1
、
Remove the wheels.
2
、
Remove the E-shaped ring for fastening the
brake soft tube, and take off the tube from the
supporting frame.
3
、
Remove the two fastening bolts for the
absorber and car frame.
4
、
Remove the joining bolts for the absorber
and the steering knuckle.
5
、
Remove the absorber assembly.