Chery Eastar, User Manual, Page: 85 / 280

Lamp Control
The indicator on the switch will flash
after the alarm lamp is turned on.
Meanwhile, if the ignition is turned on
the turn indicator lamps of the combined
instrument will also flash.
Note: When the vehicle runs in the rain,
the
vehicle glass becomes cold
dramatically and the temperature around
the glass also becomes lower, so the
moisture in the air will agglomerate and
be attached to the insides of the glass to
form dew. The theory of the dew inside
the headlamp cover is the same as it.
That is, the moisture in the air increases
as the temperature becomes high. If the
temperature becomes low, the moisture
will
agglomerate and form dew
commonly called fog phenomenon.
When the lamp has moisture and the high
or low beam lamps are turned on within
30 minutes, the moisture will gradually
start to disappear; after one hour, the
moisture naturally disappears, that is
normal phenomenon, otherwise, it maybe
has water insides. If so, please contact
Chery authorized service station for
check and service.
Check the headlamp
installment carefully when replacing
bulbs to make sure the correct
installment and good seal! Otherwise
the headlamp maybe has water or dust
insides!
It is strictly prohibited
flushing the engine compartment via a
water-cannon, especially lamps. As
the pressure of the water-cannon is
too high, it may cause lamps parts to
loosen or drop, vent hole and harness
connectors to become damp, and the
lamps have water or moisture insides,
which can’t dissipate for a long time.
At last, the dew forms, very serious.