Chery A1 2009, Service Manual, Page: 1011 / 1080

4. Replace the clamping piece if necessary:
•
Remove the stopper with a knife
•
Remove the old clamping piece
•
Replace with a new clamping piece
5. Position the glass:
•
Place the glass in the proper position
•
Make reference marks on the glass and the
body
•
Remove the glass
6. Clean the contact surface of the glass:
•
Clear any residue around the peripheral con-
tact face of the glass with glass cleaner
NOTE :
Do not touch the glass surface after cleaning.
7. Install the water resistance piece:
•
Install the water resistance piece using double- face adhesive tape as shown in the figure.
8. Apply a layer of primer M on the contact surface of
the body and apply a layer of primer M on the con-
tact face of the body with a brush.
NOTE :
Allow the primer coat to dry for a minimum of 3 minutes. Do not apply the primer to the bonding agent. Do not save
the opened primer M for later use.
9. Apply a layer of primer G on the contact surface of the glass:
•
Apply a layer of primer G on the edges and the contact surface of the glass with a brush or sponge.
•
Wipe the excess primer off with a clean rag before it dries.
NOTE :
Allow the primer coat to dry for a minimum of 3 minutes. Do not apply the primer to the bonding agent. Do not save
the opened primer G for later use.
10. Mixing the bonding agent:
•
Clean a mixing board and a scraper completely with solvent.
•
Thoroughly mix 500 grams of host crystal with 75 grams of hardener on a mixing board with a scraper.
NOTE :
Make sure that the molding is installed before the bonding agent has cured.
1 - Primer M 2 - Primer M 3 - Primer M
STATIONARY GLASS
BESM150015
BESM150016
15–
242
Chery Automobile Co., Ltd.