1224 East Warner Ave,
Santa Ana, Ca 92705
Tel: 1-714-545-5511
www.cherryaerospace.com
TS-H753A-275NP Rev: - Date: 06/03/08 DCR: 08-0734
H753A-275NP
RIVETLESS NUT PLATE® RIGHT ANGLE PULLING HEAD
Technical Data Sheet
, Page 1 of 2
Figure 1
DIMENSIONAL DATA
(see figure, all measurements in Inches)
Tool weight (without riveter): 1.20 Lbs (0.540 Kg).
CHOICE OF RIVETERS
G704B Cherry® Riveter
G750A Cherry® Hand Riveter with adaptor
750A-088
MOUNTING INSTRUCTIONS
Attach riveter to air source for correct piston
positioning; for hand powered riveters (G750A),
make sure that the pressure has been released
and that the correct adaptors are used.
Push the collet bolt assembly forward (see Figure
1) before mounting.
While holding collet bolt in a forward position,
engage 1 or 2 threads of drawbolt (18) onto
riveter head piston before threading adapter
fitting (19) into end of riveter head cylinder; turn
clockwise until snug.
Rotate pulling head to desired position and
tighten jam nut (20) to secure pulling head orientation.
Cycle the tool to make sure it is functional.
USAGE
The H753A-275NP pulling head has been specifically developed for installations of CNP 53; a carbon
composite structure application of Cherry® Rivetless NutPlate. This right angle pulling head is used in
constrained applications where straight pulling head H704-275NP is too large.
BEFORE USE, MAKE SURE THAT:
Proper air source is connected.
The sleeve and pilot are in proper working condition; any sign of damage is an indication that
components need to be replaced. No installations should be made if tooling is worn or damaged.
DURING OPERATION
Inspect the active area of the sleeve and pilot regularly.
Keep the tool clean, especially the pilot, sleeve and jaws; pay special attention when sealants are used.
If stem slippage occurs, the jaws need to be either cleaned or replaced.
PREVENTATIVE MAINTENANCE
Clean the sleeve, pilot, jaw set and collet every 1,000 installations or when failures occurs; use a wire
brush to clean the copper deposited inside the jaw set.
Lubricate outside of the jaw set with Lubriplate® or similar light lubricant.
