Adapter comes partially assembled as
shown at left.
Step 1:
Disassemble the adapter using the
supplied 2.5mm Allen wrench as shown.
Step 2:
Using the 2.5mm Allen wrench, remove
the 4 top screws from the agitator assembly.
Step 3:
Using a small crescent wrench (not
supplied), remove the 4 extension legs from the
agitator assembly.
CAUTION:
Agitator top is now loose. ASAP,
please install lower adapter as shown in
Step 4.
Step 4:
Using a 3mm
Allen wrench, attach
the housing cap using
the 4 socket head cap
screws.
Step 5:
Using a 2.5mm Allen wrench, slide the
shaft adapter over the pin and tighten.
Step 6:
Using a 2.5mm Allen wrench, attach
the housing cap to the lower plate using the
enclosed screws.
Step 7:
Position spline gear approximately
5mm above the adapter plate and tighten with a
2.5mm Allen screw.
5mm
