English — 11
NORMAL MAINTENANCE
NO
lubrication is required for any moving parts, motor, bearings or sharpening surfaces.
There is no need for water on abrasives. The exterior of the sharpener may be cleaned by
carefully wiping with a damp cloth. Do not use detergents or abrasives.
Once a year or so as needed, you can remove metal dust that will accumulate inside the
sharpener from repeated sharpenings. Remove the small rectangular clean-out cover
(Figure 11) that covers an opening on the underside of the sharpener. You will find metal
particles adhered to a magnet attached to the inside of that cover. Simply rub off or brush
off accumulated filings from the magnet with a paper towel or tooth brush and reinsert
the cover in the opening. If larger amounts of metal dust have been created or if the
Stage 2 disk has been cleaned (using the cleaning/dressing tool) you can shake out any
remaining dust through the bottom opening when the cover is removed. After cleaning,
replace the cover securely with its magnet in place.
Figure 11. Clean-out cover.
SERVICE
In the event post-warranty service is needed, return your sharpener to The Legacy
Companies factory where the cost of repair can be estimated before the repair is
undertaken. Outside the USA, contact your retailer or national distributor.
Please include your return address, daytime telephone number and a brief description of
the problem or damage on a separate sheet inside the box. Retain a shipping receipt as
evidence of shipment and as your protection against loss in shipment.