4
1 - Delivery and warranty
1.1 - Introduction
CAUTION!
The symbols used in this manual draw the reader’s attention to points and
operations that are hazardous to the operator’s personal safety or that risk
damaging the machine.
Do not use the machine unless you have read and properly understood these
notes.
CAUTION!
For reasons of clarity, some of the illustrations appearing in this manual show the
machine or parts of it with its panels or guards removed.
Never use the machine in this condition; only use it when it is fully equipped with
the guards and in good working order.
The manufacturer forbids the reproduction, even partial, of this manual or the use
of its contents for purposes other than those expressly allowed.
Any breach in this regard shall be punishable by law.
1.2 - Storing and using this manual
This manual uses text and illustrations to familiarise users with the machine and
explain the instructions and essential criteria for its transport, handling, use and
maintenance. Read this manual carefully before using the machine. Store this
manual with care near the machine so that it can be readily available for future
reference.
If the manual is lost or damaged, you can request a copy from your dealer.
If you sell the machine, report the new owner's identification and address to the
manufacturer.
The manual reflects the state of knowledge at the time of sale of the machine, and
cannot be considered inadequate in the light of more recent experience and
updates. The manufacturer reserves the right to update the products and manuals
without being obliged to update previous products and manuals, except in
exceptional circumstances. In case of doubt, contact your local service centre or
the manufacturer.
The manufacturer is committed to continuously improving its products. For this
reason, the manufacturer welcomes any reports or proposals geared towards
improving the machine and/or the manual. The machine is delivered to the
customer with the warranty conditions applicable at the time of sale.
Please contact your dealer for any further information.
1.3 - Warranty
The user is not authorised to tamper with the machine in any way.
Contact your dealer if you encounter any anomalies.
Any attempt to dismantle, modify or tamper with any part of the machine by the
user or unauthorised personnel will immediately void the
Declaration of
Conformity
drawn up pursuant to Directive 2006/42/EEC and the warranty, and
17
English
7 - Maintenance
7.1 - Instructions
CAUTION!
Maintenance and cleaning must always be carried out with the machine at a
standstill and disconnected from the mains power supply.
Always keep the maintenance zone clean and dry.
Do not allow unauthorised persons to intervene on the machine.
Parts and tools must be replaced using original spare parts at authorised service
centres.
The blade pack must be handled while wearing Kevlar safety gloves that meet
accident-prevention criteria.
The machine is not designed to operate inside a cold room: this could
seriously damage the electrical components sensitive to condensate (which
forms at low temperatures) and also alter the viscosity of the grease and/or
lubricating oil in the gearbox housed inside it, jeopardising the machine’s
correct operation and causing potential failures.
7.2 - Lubrication
The shaft and the sliding rods should be greased using vaseline grease for
improved sliding of the slide.
7.3 - Cleaning the machine
CAUTION!
Disconnect the machine from the mains power supply before cleaning it.
Do not clean the machine using a water jet.
Only use non-toxic detergents specifically formulated for cleaning components
used with foodstuffs.
The blades are made of grade AISI 420 steel and may rust if they are not dried
after washing them.
The blade pack must be handled while wearing Kevlar safety gloves that meet
accident-prevention criteria.
7.3.1 - Removing the plexiglass cover
(Fig. 7.2.1)
To remove the plexiglass protection, proceed as follows:
-
Grip the cover (1) and lift it until it lies vertical.
-
Slide the cover off the pins towards the left.
Fig. 7.2.1
1
