USER'S MANUAL, NS40
CHECKPOINT SYSTEMS, INC. CONFIDENTIAL AND PROPRIETARY INFORMATION, FOR INTERNAL USE ONLY
Document No. 10035527
Rev. 00
Page 12 of 21
3.4
Remaining Hardware
3.4.1
Matching Board
An important part of the antenna in the RF Circuit is the antenna impedance matching board or "coupler
board" for short. The FS Technician should never have to inspect/repair a coupler board, because they are
Factory-Installed and Ready "As Manufactured." On the NS40 coupler board, there is no hardware tuning
(no PCB Jumpers, which is different from Evolve).
3.4.2
GPIO Module
The NEO Controller also features a simple I/O board has input, outputs, and a Serial data (RS-232) port.
The NEO Quick Start guide offers complete pin-out tables and basic software setup instructions.
The available interfaces are defined below.
GPO J6
This RJ-45 port is for triggering external devices.
There are Relay NO/NC contact pairs, which must be enabled using DMS.
2 unique relays are present (2 available in hardware/software).
GPI J8
This RJ-45 port is for accepting input signals.
There are 4 inputs which can be "mapped" to various events (advanced setup required).
CPiD-RF J5
There is also a CPiD-RF Serial Data interface available (opening the system is required); the ferrite core in the
installation kit shall be used on the Cat 5e / Cat 6 or better cable, if installed, to the J5 serial port.
The NEO Installation Manual describes the hard-wired connection which is used to integrate CPiD-RF
Deactivator (or deactivator chain using the CPiD Communications Module or "CAM").
3.4.3
Power Supply
The Power Supply is part of the system. See section 6.0 for all
