QLS250, QLS450, QLS650, and QLS800
Rack Mounting for Check Point Appliances | 8
Before you can attach each appliance rail to the side of the appliance, you must remove the inner appliance
rails from the outer rack rails.
To remove the inner appliance rail from the telescopic rail unit:
1. Extend the inner appliance rail from the outer rail until the rails locks in place.
2. Press the inner rail release latch, as shown, and pull the inner appliance rail straight out.
3. Do steps 1 and 2 again for the other telescopic rack rail unit.
Item
Description
1
Inner rack rail
2
Release latch
3
Outer appliance rail
Legend
To install the inner appliance rails to the appliance:
1. Place the appliance rail on the side of the appliance and make sure:
n
The release latch is facing away from the appliance
n
The arrow on the release latch points to the front of the appliance
n
The appliance rail is longer than the appliance
2. Install the appliance rails to the side of the appliance with the six provided screws. Refer to the below
appliance rail image.
Note - Do not over-tighten the screws. Check Point recommends that you leave
the rail mounting screws loose until the server is completely installed. This eases
installation by preventing binding of the server in the rack.
