Check Point Pointsec PC, Installation Manual

Page: 24 / 44

Review precheck.txt
18
Central Log Transfer Settings
Here you can specify how the central log transfer should be managed.
Table 1-6 Central Log Transfer Settings
Setting Description
CentralLogInitialStartDelay=
First delay before any action. The values are in minutes.
Minimum value = 0
Maximum value = 180
CentralLogFirstDelay=
Delay after the first action, for example, the first attempt
to send the local log file to the central log before the real
cycle starts. The values are in minutes.
Minimum value = 0
Maximum value = 120
CentralLogUpdateInterval=
Update interval cycle time. The values are in minutes.
Immediately after installation, Pointsec PC checks tries to
send the local log file to the central log, then it waits 90
minutes before sending the local log file again (90
minutes is the default if no other value has been set for
CentralLogFirstDelay ). After this second sending of the log
file, the checks will be carried out at the interval that has
been specified for this setting.
CentralLogRetryInterval=
Time between retries. The values are in minutes.
Minimum value = 1
Maximum value = 20