Appliance Configuration
Check Point 1400 Appliances Centrally Managed Administration Guide R77.20.85 | 62
Configuration tab
•
Network name (SSID)
- Enter a name for the wireless network or use the default name.
This is the name shown to clients that look for access points in the transmission area.
•
Use Hotspot
- Select this checkbox to redirect users to the Hotspot portal before allowing
access from this interface. Hotspot configuration is defined in the Device > Hotspot page.
Wireless Security
•
Protected network (recommended)
- This is the recommended wireless security setting.
•
Security type
- Select the security technology used in your wireless network. WPA/WPA2 is
the most compatible option. WPA2 is the most secure.
•
Encryption type
- Select the encryption method.
•
Authenticate using
- Select
Password
or
RADIUS server (Enterprise mode)
to determine
how the users authenticate.
The Password option allows a single password for all users. This option is known as
WPA
Personal
.
The
RADIUS servers
(Enterprise mode)
option requires defining RADIUS servers in the
Users & Objects > Authentication Servers page. Each user that tries to connect to the
wireless network is authenticated through the RADIUS server. This option is also known as
WPA Enterprise
.
•
Network password
- When authenticating using a password, enter a password or click
Generate
for an automatically generated password.
Show
- To see the password, select this option. To hide it, clear the checkbox.
•
Unprotected network (not recommended)
- Without a password, any wireless client can
connect to this network. This option is not recommended.
Advanced Settings
•
Hide the Network Name (SSID)
- When selected, this wireless network name is not
automatically shown to users scanning for them. Connecting to the wireless network can be
done manually by adding the specified network name.
•
Allow Station-to-Station Traffic
- When selected, allows wireless stations on this network to
communicate with each other. When cleared, traffic between wireless stations is blocked.
•
Enable MAC address filtering
- When selected, by default, all wireless devices are not allowed
to connect to the wireless network. To allow a specific device to connect, add a new MAC
address to the table. Click
New
, enter the device's
MAC address
and click
Apply
.
Wireless Network tab
Interface Configuration
•
Assigned to
- Select
Separate network
or one of the existing configured networks. When
selecting a separate network configure this information:
•
IP address
Note
- 1400 appliances support both IPv4 and IPv6 addresses.
•
Subnet mask
- for IPv4 addresses
•
Prefix length -
for IPv6 addresses
Summary of Contents for L-71
Page 122: ......
