Introduction
26000 and 28000 Appliances Getting Started Guide | 34
The window shows volume and disk information.
To monitor the RAID status of the storage devices using SNMP:
Set up SNMP traps to send information about the RAID.
Use OID:
1.3.6.1.4.1.2620.1.6.7.7
For more about how to configure the SNMP settings on the appliance, see the
Gaia Administration Guide
for the applicable version.
To hot swap a storage device:
Important
- Make sure that there is at least one fully synchronized storage device in the system.
Note
- This cannot be done on 26000THS.
1.
When the system is up, remove the failed storage device.
2.
Wait 15 seconds.
The appliance recognizes that you removed a storage device.
3.
Insert a new storage device. If necessary, you can reboot the appliance with one storage device and
install the new storage device later.
The system automatically adds the new storage device to the RAID configuration.
