Page 20
Chapter 5
Customer Replaceable Parts
For maximum availability and easy maintenance, the appliance has many customer replaceable parts.
Important
- customers are prohibited by warranty and support agreements from changing
any parts or altering the hardware in any way except as noted below, or as directed by
Check Point technical support.
In This Chapter
Installing and Removing Line Cards
20
Installing and Removing Transceivers
21
Installing and Removing Power Supplies
22
Installing and Removing Hard Disks
23
Installing and Removing Memory
25
Installing and Removing Cooling Fans
28
Installing and Removing the System Board Battery
29
Installing and Removing a LOM Card
30
Installing and Removing Line Cards
This section presents the procedures for removing and installing Line Cards.
There are three Line Card slots in the front of the appliance.
Important
- Make sure that you are electromagnetically grounded
when performing these procedures. Static electricity can damage the
appliance.
To remove a Line Card:
1. Turn off the appliance.
2. Loosen the thumb screws on the two sides the Line Card.
3. Squeeze the spring-loaded section of the ejector handle in the direction of the outer edge of the Line
Card, and turn the ejector out. Do this at the same time on the right and the left ejectors.
4. Holding the ejector, pull the Line Card out of the slot.