28
VR76
english
10.0 - COUPLING TO THE TRACTOR
10.1
- The machine must be coupled to the tractor on flat ground.
10.2
- Check that the three-point linkages are of a compatible category.
10.3
- Bring the tractor up to the machine,
taking care not to get between the two at
this stage
, and proceed with coupling only when the tractor is stationary. Fix the three
coupling arms with the relative pins and insert the appropriate safety split pins (fig. 4).
10.4
- Limit sideways movements and keep the machine parallel with the tractor,
using the stabilizer chains and arm adjustment device (fig. 5).
10.5
- Adjust the third point arm until the machine coupling is at right angles (fig. 6).
10.6
- If applicable, position the support foot as shown in fig. 7.
11.0 - UNCOUPLING FROM THE TRACTOR
-position the equipment on the ground, only in a flat area;
-lower the support foot, if applicable;
-make certain that the equipment remains stable;
-remove fixing pins and plugs, taking care not to get between the equipment and the
tractor;
-ensure again that everything is stable, bearing in mind all eventualities.
FIG. 6
FIG. 4
FIG. 7
FIG. 5
