VS-MIDI
MIDI Interface for Vermona Synthesizer
Model 8-434 ver. 1.0
Copyright © 2009 CHD Elektroservis
All rights reserved. No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
3
1. INTRODUCTION
VS-MIDI is a MIDI retrofit for the Vermona Synthesizer. The device enables the instrument to
be controlled via MIDI as a MIDI expander. VS-MIDI controls VCO, VCF, VCA and EG of the
instrument.
1.1. PARTS OF MIDI INTERFACE KIT
The supplied MIDI interface kit contains all necessary parts, materials, and detailed installation
instructions.
Pic. 1-1 – Parts of interface kit
The kit contents:
1. MIDI Interface board
2. Supply bunched cables with
connector and LED
3. Signal bunched cables with
connector
4. 2x connector DIN-5 with cable
(including screws etc.)
5. CD-ROM with the user and
installation
manuals
and
software
1.2. GENERAL INFORMATION
The installation of all interface components is easy. If you follow the instruction from this manual
there will be no major problems during the installation procedure. All original features of Vermona
Synthesizer instrument are kept. The instrument can be used the same way as before the retrofitting.
The following tools are necessary for the installation: screwdriver, Phillips screwdriver, driller,
drills 3,2 a 16 mm, smaller rasp, soldering iron (a low heat iron and soldering paste).
Attention ! Disconnect the Vermona instrument form the mains prior to the installation.
Otherwise, there is a risk of the electric shock!
The producer is not responsible for any eventual mechanical or electrical damage of
the Vermona instrument caused by the infringement of the described installation
procedure or by careless manipulation during the installation of the MIDI interface!
