Vermona Synthesizer MIDI Interface
Vermona Synthesizer MIDI Interface
Vermona Synthesizer MIDI Interface
Vermona Synthesizer MIDI Interface
VS
VS
VS
VS----MIDI
MIDI
MIDI
MIDI Installation
Installation
Installation
Installation Manual
Manual
Manual
Manual
8
88
8----434 /
434 /
434 /
434 / v. 2.00
v. 2.00
v. 2.00
v. 2.00
Copyright © 2022 CHD Elektroservis. All rights reserved.
No part of this publication may be reproduced in any form without the written permission of CHD Elektroservis.
11
11
11
11
a) Add bunched cables to original cables – use original glazing sprig. Blue, green and yellow wires are in
instrument’s cover; black, red, and shielded wires are directed to bottom basis part of the instrument (pic.
2.4.2).
b) Solder shielded wire Nr. 1 (red – one wire of shielded twin-lead) to left lead of R25 resistor (near operational
amp IS1) on VCO board – pad (1) CV. Cleanse an oxyded layer on the resistor lead before soldering (fig. 2.4.3).
c) Solder shielded wire Nr. 3 (white – the other wire of shielded twin-lead) to UTS signal on VCO board – solder
lug (3) UTS (fig. 2.4.3).
d) Solder the black wire Nr. 2 (ground) to ground potential on VCO board – solder lug (2) GND (fig. 2.4.3).
e) Solder the red wire Nr. 7 to signal GATE on VCO board – solder lug (7) Gate (fig. 2.4.3).
Fig. 2.4.4
Fig. 2.4.4
Fig. 2.4.4
Fig. 2.4.4
Fig. 2.4.5
Fig. 2.4.5
Fig. 2.4.5
Fig. 2.4.5