Introduction
Congratulations on the purchase of your new CHAUVET lighting effect. We are confident you will
enjoy many trouble free hours with this unit. To assist with the care and use of the product we
have prepared this short guide.
Operation
This lighting effect has been designed to function on a mains power supply of either 120V~60Hz
or 230V~50Hz and has been fitted with a suitable power plug for use with your local voltage.
Check the label on the unit and the power plug for the correct voltage.
When connected to the mains power supply the unit should illuminate and the reflector dish
should rotate.
The duty cycle for this effect should be no more than 15 minutes on then 15 minutes off.
Replacing Lamps
1.
Disconnect from main power supply before attempting to replace lamp.
2.
Ensure that the unit is sufficiently cool, before removing blown lamp.
3.
Never touch new lamps with your fingers; use a tissue or a cloth.
In order to replace the lamp, disconnect from main power supply first, and unscrew the set
screws to remove the lamp replacement cover, which is highlighted on the diagram (fig.1). Only
use the appropriately rated lamps as use of any other lamp type may cause the unit to be non-
operational.
Finally before switching on, check that the lamp is housed correctly in the lamp holder and that
the lamp replacement cover has been screwed back into place.
If after replacement of the lamp, the unit is still not working then please contact
CHAUVET for servicing.
Cleaning
The most important part of your lighting effect to keep clean is the colored dome and the reflector
dish as they allow the light output to transmit. These should be cleaned with a soft damp cloth.
The body of the unit may also be cleaned in the same way. We recommend internal cleaning be
carried out by a fully qualified technician.
Maintenance & Servicing
Work on internal parts should be carried out by a qualified technician. Removal of any covers
other than the lamp replacement access is considered a breach of warranty and will not be
covered under any such agreement unless authorized first by
CHAUVET.
Troubleshooting
• If the unit is not functional – check main power supply is ‘on’ and check fuses.
• If the unit is functional but lamp does not light - lamp may require replacing.
If after trying this solution you still have a problem contact your dealer or CHAUVET.
Caution
No user serviceable parts inside, please refer to CHAUVET for service.
Power Connections
The unit is supplied with a power plug appropriate to its voltage and destination. Should any other
connections be required they must be carried out with the following configuration.
Earth = Green/Yellow cable
Neutral = Blue cable
Live = Brown cable
In the USA & Europe, it is required that all plugs are 3-pin type i.e. with Earth/Ground connection
In the UK, it is required that all mains plugs are fitted with 5A fuses.
Technical Specifications
Power
120V~60Hz AC
230V~50Hz AC
Lamps
1 x 120V 75W
1 x 230V 75W
Dimensions
254mm / 10in
Weight
2.3kg / 5lbs
User Information
(Please complete for your records)
Date Purchased:
/
/
Serial No:
Dealer Stamp:
Model:
YA-210 POLICE BEACON
Fig. 1
Lamp Replacement Cover
Mounting Base
