7
Lamp : Discharge lamp MSD 250W
Color Temperature : 8000K
Average Life : 2000 hours
1. Always switch off the main supply and never handle the lamp or luminaries when is
hot.
2. Do not touch the bulb with bare hands. If this happens, clean the lamp with denatured
alcohol and wipe it with a lint free cloth before installation.
3. The lamp generates UV radiation. Never operate the lamp without appropriate shielding.
4. When burning, the lamp operates at high pressure and there is a slight risk of arc tube
rupture. The risk increases with age, temperature and improper handling of the lamp. Do
not use the lamp any longer than its specified life.
5. Make sure the lamp is located in the center of the reflector for the best spot.
Diagram for Lamp changing
3.1 How to change the frequency 50Hz / 60Hz
1. Always switch off the main supply
, open the p
lastic base-cover.
Find
the ballast on the
housing-base.
2. Loose the screw of the red wire on
the ballast, and change the frequency.
3. Reinstall all.
4. How To Set The Unit
4.1 Control Panel
Display
To show the various menu and the selected functions.
LED
DMX
On
DMX input present
MASTER
On
master mode
SLAVE
On
slave mode
SOUND
Flashing
sound activation
Button
MENU
to select the programming functions
DOWN
to go backward in the selected functions
UP
to go forward in the selected functions
ENTER
to confirm the selected functions
Remote controller input
By connect to the 1/4” microphone jack to control the unit for Stand by, Strobe/Next and
Fast/Slow function.
Sensitivity
To adjust the microphone-receiving sensitivity.
Microphone
To receives audio signal for sound activation.
DMX input/output
For DMX512 link, use 3-pin XLR plug cable to link the unit together.
5. How To Control The Unit
You can operate the unit in three ways:
1. By master/slave built-in preprogram function
2. By easy controller
3. By universal DMX controller
No need to turn the unit off when you change the DMX address, as new DMX address
setting will be effected at once. Every time you turn the unit on, it will show A660 on the
display and move all the motors to their ‘home’ position and you may hear some noises for
about 20 seconds. After that the unit will be ready to receive DMX signal or run the built in
programs.
5.1 Master/Slave Built In Preprogrammed Function
By linking the units in master/slave connection, the first unit will control the other units to
give an automatic, sound activated, synchronized light show. This function is good when you
want an instant show. You have to set the first unit in master mode
and select
(show 1) or
(show 2) mode. Its DMX input jack will have nothing plugged into
it, and Its master LED will be constantly on and sound LED will flash to the music. The other
units will have to set in slave mode
and select
(normal) or
(2 light
show) mode, Their DMX cables plugged into the DMX input jacks (daisy chain) and the slave
led lights will constantly on.
2-light show
In
(slave mode),
means the unit works normally and
means 2-light
show. In order to create a great light show, you can set
on the second unit to get
contrast movement to each other, even if you have two units only.
