6
Shaking
168~247
245
135
Slowest speed
128
Slowest speed
128
Stopped
121-134
Light green
121-127
Light green
116-127
Amber- Light green
114-120
112-127
Amber
108-113
Magenta-Amber
101-107
Amber
103-115
Magenta
94-100
96-111
Magenta
90-102
Shutter
88-167
Pink-Magenta
88-93
Pink
81-87
80-95
Pink
77-89
Orange-Pink
74-80
Orange
67-73
Orange
64-76
64-79
UV Purple-Orange
61-66
UV Purple
54-60
UV Purple
52-63
Green-UV Purple
47-53
48-63
Green
41-46
Green
39-51
Yellow-Green
34-40
32-47
Yellow
27-33
Yellow
26-38
Blue-Yellow
21-26
16-31
Dimmer
08-87
00-15
120
10
Blue
13-25
Blue
14-20
White-Blue
07-13
Blackout
00-07
Stopped
00-09
White
00-12
White
00-06
5.2 Easy Controller
The easy remote control is used only in master/slave mode. By connecting to the 1/4”
microphone jack of the first unit, you will find that the remote control on the first unit will
control all the other units for Stand by, Strobe/Next and Fast/Slow function.
1.
STAND BY
: To blackout all the unit.
2.
STROBE/NEXT
: Under FAST mode, the light will strobe in three different ways:
a.) Strobe in different gobos and colors.
b.) Synchronous strobe in white color.
c.) Two-light strobe in white color.
If the unit in slow mode, press NEXT button to choose desired color and gobo. It will
change ten colors and then change one gobo.
3.
FAST/SLOW
: When the LED is off, it is in FAST mode. The unit’s movement- Pan/Tilt &
Gobo/Color is sound activated. If the LED on, it is in SLOW mode, Pan/Tilt is sound
activated but Gobo/Color wheel are static, controlled by Next button.
5.3 Universal DMX Controller
If you use a universal DMX controller to control the units, you have to set DMX address
from 1 to 512 channel so that the units can receive DMX signal.
Press the
MENU
button up to when the
is showing on the display. Pressing
ENTER
button and the display will blink. Use
DOWN
and
UP
button to change the DMX512
address. Once the address has been selected, press and keep
ENTER
button pressed up to
when the display stops blinking or storing automatically 8 seconds later. To go back to the
functions without any change press the
MENU
button again.
Please refer to the following
diagram to address your DMX512 channel for the first 4 units.
3. Lamp
Becau
se of its high internal pressure, there might be a risk that the Discharge lamp would
explode during operation. The lamp emits intense UV radiation which is harmful to the
eyes and skin. The high luminance of the arc can cause severe damage to the retina if
looked directly at the lamp.
In case of replacement of the lamp or maintenance, do not open the
fixture within 15 minutes until the unit cools down after switching off.
