Page 14 of 17
SlimPANEL™ TRI 24 IP User Manual (Rev. 4)
Touch Control
Panel Lock
To enable the touch panel lock, follow the instructions below:
1. Press
<MENU>
repeatedly until
PASS
shows on the display.
2. Press
<ENTER>
.
3. Press
<UP>
or
<DOWN>
until
ON
shows on the display to enable the touch panel
lock.
To disable the touch panel lock so you can resume functionality, follow the steps below:
1. Press
<UP>
,
<DOWN>, <UP>
,
<DOWN>, <ENTER>
to disable the touch panel
lock.
2. Press
<MENU>
to move through the menus as normal.
In situations where water may flow onto the touch display, use the Touch Panel Control
Lock so that the water does not reset the product’s settings.
Master/Slave
Mode
The Master/Slave mode allows a single SlimPANEL™ TRI 24 IP unit (the “master”) to
control the actions of one or more SlimPANEL™ TRI 24 IP units (the “slaves”) without
the need of a DMX controller. The master unit will be set to operate in a standalone
mode, while the slave units will be set to operate in Slave Mode. Once set and
connected, the slave units will operate in unison with the master unit.
Configure the units as indicated below.
Slave units:
1. Press
<MENU>
repeatedly until
Addr
shows on the display.
2. Press
<ENTER>
to accept.
3. Set the DMX address to
001
.
4. Connect the DMX input of the first slave unit to the DMX output of the master unit.
5. Connect the DMX input of the subsequent slave units to the DMX output of the
previous slave unit.
6. Finish setting and connecting all the slave units.
Master unit:
1. Set the master unit to operate in standalone mode.
2. Make the master unit the first unit in the daisy chain.
•
Configure all the slave units before connecting the master unit to the daisy
chain.
•
Never connect a DMX controller to a DMX string configured for Master/Slave
operation because the controller may interfere with the signals from the
master unit.
•
Do not connect more than 31 slave units to the master unit.
