Scorpion™ BLU User Manual (Rev. 6)
Page 19 of 21
Troubleshooting
Symptom
Possible Cause
Possible Action
Circuit breaker or fuse
keeps blowing
Excessive load on the circuit
Make sure that the total load does not
exceed 80% of the breaker or fuse
nominal current
Short circuit along the power lines
Check the power lines and power cords
Product does not power up
No energy on power outlet
Check power outlet
Change to another outlet
Loose or damaged power cord
Check the power cord
Blown fuse
Replace blown fuse with a good one of
the same type and rating
Internal problem
Send product for repair
Product does not respond to
DMX
Wrong starting address on the product
Set the correct starting address on the
product
Use the right fader(s) on the controller
Wrong DMX personality on the product
Set the correct DMX product’s personality
Assign the faders accordingly
Wrong polarity setting on the DMX
controller
Change the signal polarity on the
controller
Loose or damaged DMX cable
Check the DMX cable before the faulty
unit
Internal problem
Send product for repair
Intermittent DMX Problems
Signal cables are not DMX compatible
Replace non DMX cables with true DMX
cables
Interference with AC or radio signals
Keep DMX cables away from AC wires or
radio equipment
DMX cable too long
Install an optically coupled DMX amplifier
right before the product with intermittent
problems
Too many products connected
Install an optically coupled DMX amplifier
after unit #32
Terminator not connected
Install a terminator.
If you still experience problems after trying the above solutions, contact CHAUVET® Technical
Support.
