Replacing Lamps
1. Always disconnect the unit from main power supply before attempting to replace a lamp or fuse.
2. Make sure that the unit is sufficiently cool before removing a blown lamp.
3. Never touch a new lamp with your fingers, use a tissue or a dry clean cloth. Touching a halogen lamp
with you r fingers will greatly reduce lamp life.
4. Unscrew the lamp replacement cover, which is highlighted on the diagram (fig.1). Only use the appro-
priately rated lamp, as use of any other lamp type may cause the unit to be non-operational.
5. Place the prongs of the lamp into the sockets located inside the unit. Check to make sure that the
lamp is housed correctly in the lamp holder and will not fall out.
6. Screw the lamp replacement cover back into place.
Note:If the unit is still not working after lamp replacement, please contact your dealer or
CHAUVET for servicing.
Replacing Fuses
1. Always disconnect the unit from main power supply before attempting to replace a lamp or fuse.
2. Unscrew the fuse holder cover to reveal the fuse.
3. Remove the old fuse.
4. Place new fuse inside the holder. **Notes on fuses - see below**
5. Screw the fuse holder cover back on.
Notes on fuses
This unit has a label attached which indicates the correct fuse rating. If needed, you can also find this
listed as part of the specifications for the unit later in this guide. It is critical that replacement fuses are
of the correct rating. Failure to use the correct fuse could damage the lighting effect beyond economic
repair.
If the unit is still not working after fuse replacement then please contact your dealer or CHAUVET for
servicing.
Specifications
Voltage:
AC 110V 50/60Hz or 240V 50Hz
Fuse:
7 Amp 125V, 5 Amp 250V
Lamp:
EHJ, 24V 250W
Motors:
DC 12V 60 RPM
DC 12V 40 RPM
DC 12V 20 RPM
Colors:
Red, Yellow, Blue, Orange, Green, White
Weight:
19 lbs
Dimensions: 14.25in x 11.25in x 11.25
