MVP™ Driver QRG
Page 8 of 12
Back Panel
Connections
Disconnect power before connecting other equipment to the
MVP™ Driver.
Number Description
1
DIP SWITCHES
addresser that can address up to 4 Drivers.
Up = Off; Down = On.
You will identify each Driver’s Sender address within the LED Studio
software application.
Note
: The MVP™ Driver is the Sender, and the panels are the Receiver(s).
2
OUTPUT
can be used to connect to the next MVP™ Driver. Use a 9-pin D-
Sub serial cable for connection (not included).
3
INPUT
(don’t use if #1)
connection from the previous MVP™ Driver. Use
a 9-pin D-Sub serial cable for connection (not included).
4
U - MAIN OUT
is the primary etherCON® signal output that connects to
the first MVP™ in a series.
5
Signal
LED indicator flashes Green when the video connection signal is
being received by the MVP™ Driver.
6
Power
LED indicator displays Red when power is being received by the
MVP™ Driver.
7
D - BACKUP
is the secondary signal output and is pre-configured as a
backup that provides complete signal reproduction at 1024 X 512 pixels.
You can also configure both outputs to run separately providing a
resolution of up to 2048 x 640. This configuration eliminates the backup.
8
USB – DATA
IN
connects to the content software for addressing.
9
DVI-D – VIDEO IN
connects to a video source. The DVI signal must be a
direct digital signal in. You cannot use an analog to digital adaptor.
10
Power On/Off
11
Plug 100 – 240 VAC 50/60 Hz
1
2
4
3
7
11
10
9
8
5
6
Summary of Contents for MVP Driver
Page 1: ...Quick Reference Guide ...
