Chauvet Gobo Zoom LED 2.0, User Manual, Page: 12 / 15

Page 12 of 15 Gobo Zoom LED 2.0 (Rev. 02)
3-Pin to 5-Pin Conversion Chart
If you use a controller with a 5-pin DMX output connector, you will need to use a
5-pin to 3-pin adapter. The chart below details a proper cable conversion:
3-P
IN TO
5-P
IN
C
ONVERSION
C
HART
Conductor
3-Pin Female (Output) 5-Pin Male (Input)
Ground/Shield
Pin 1 Pin 1
Data ( - ) signal
Pin 2 Pin 2
Data ( + ) signal
Pin 3 Pin 3
Not used
Pin 4
Not used
Pin 5
Setting up a DMX Daisy Chain
1. Connect the (male) 3-pin connector side
of the DMX cable to the output (female)
3-pin connector of the controller.
2. Connect the end of the cable coming
from the controller which will have a
(female) 3-pin connector to the input
connector of the next product consisting
of a (male) 3-pin connector.
3.
Then, proceed to connect from the
output as stated above to the input of
the following product and so on.
Universal DMX Controller
Continue the link
This drawing
provides a general
illustration of the
DMX input/output
panel of a lighting
product.