4
_
-
B. MAIN FEATURES
MAIN FEATURES
•
Voltage: AC 120V 60Hz or 230/240/250V 50/60Hz
•
Bulb: ELC3 24V 250W(300hrs)
•
The unit is a DMX512 projector. It features full DMX512 control, 14 gobos plus
open and 14 colors plus white, accurate focusable optics system and stepper
motor with blackout feature. Fan cooled.
•
It can be operated by DMX512 control or can be used as a stand-alone unit
running via sound activation.
•
It can be linked together in master/slave combination, as many as required in 4
channels and run by built-in preprogrammed chase sequences automatically or
by sound activation through an internal microphone to create an intelligent effect.
•
Please use a 3 pin XLR cable/plug when connecting them together.
•
It features different preprogrammed chase patterns.
•
Dimensions: 338mm x 320mm x 216 mm
•
Weight: 9 kg / 19.8 lbs
C. LAMP
LAMP
ELC3 24V 250W(300hrs)
•
Always switch off the mains supply and never handle the lamp or luminaire when it
is hot.
•
Do not touch the bulb with bare hands. If this does happen, clean the lamp with
denatured alcohol and wipe with a lint free cloth before installing.
D. HOW TO CONTROL THE UNIT
( 1 ) By universal DMX controller
The DMX512 is widely used in intelligent lighting control, with a maximum of 512
channels.
A DMX512 system requires a controller, lighting equipment and cable. These are
connected together in a “daisy chain” with the terminator at the end. The cable
cannot be branched or split to a “Y” cable.
The terminator requires a 90-120 Ohm 1/4 Watt resistor soldered between two
signal cables.
The DMX512 uses a very high-speed signal. Inadequate or damaged cables, bad
solder joints or corroded connectors can easily distort the signal and shut down
the system. A reliable DMX512 system starts with good quality cables.
Each lighting unit needs to have an address set to receive the data sent by the
controller. The address number is between 0-511. The end of the DMX512
system should be terminated reducing signal errors.
3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
