B. MAIN FEATURES
•
Voltage
：
AC 120V~60Hz or 230V-250V~50 Hz
•
Bulb
：
ELC3 24V 250W
•
The unit is a DMX512 scanner. It features full DMX512 control, 14 gobos/colors
plus open, accurate focusable optics system and stepper motor with blackout
feature. Fan cooled.
•
It can be operated by DMX512 control or can be used as an individual unit
without a control.
•
It can be linked together in master/slave combination units, as many as
required in 4 channels and run by built-in preprogrammed chase sequences
automatically or by sound activation through an internal microphone to create
an intelligent effect.
•
Please use a 3 pin XLR cable/plug when connecting them together.
•
It features different preprogrammed chase patterns.
•
Dimensions
：
DMX-100
263 x 314 x 202 mm / 10.35in x 12.36in x 7.95in
DMX-100S / DMX-100B
470 x 314 x 245 mm / 18.5in x 12.36in x 9.65in
•
Weight
：
7.7 kg / 16.94 lbs ( DMX-100 )
10 kg / 22 lbs ( DMX-100S / DMX-100B )
C. LAMP
ELC3 24V 250W (300 Hrs)
•
Always switch off the mains supply and never handle the lamp or luminaire
when it is hot.
•
Do not touch the bulb with bare hands. If this does happen, clean the lamp
with denatured alcohol and wipe with a lint free cloth before installing.
D. HOW TO CONTROL THE UNIT
( 1 ) By universal DMX controller
The DMX512 is widely used in intelligent lighting control, with a maximum of 512
channels.
DMX +
COMMON
DMX -
advisable to connect a DMX terminal.
pin3 (DMX+) of the last fixture.
transmission problems and interference. It is always
(Resistance 120 ohm 1/4W) between pin2 (DMX-) and
Termination reduces signal errors and to avoid signal
INPUT
DMX512
1
2
3
2
1
OUTPUT
1
2
3
120 ohm 1/4W
1
2
3
4
3
2
3
1
ü
A DMX512 system requires a controller, lighting equipment and cable. These
are connected together in a “daisy chain” with the terminator at the end. The
cable cannot be branched or split to a “Y” cable.
ü
The terminator requires a 90-120 Ohm 1/4 Watt resistor soldered between two
signal cables.
ü
The DMX512 uses a very high-speed signal. Inadequate or damaged cables,
bad solder joints or corroded connectors can easily distort the signal and shut
down the system. A reliable DMX512 system starts with good quality cables.
ü
Each lighting unit needs to have an address set to receive the data sent by
the controller. The address number is between 0-511. The end of the
DMX512 system should be terminated reducing signal errors.
ü
3 pin XLR connectors are more popular than 5 pin XLR.
3 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+)
