Page 9 of 25
Rogue Outcast 2 Hybrid User Manual Rev. 1
Setup
6. Using the lamp base, push the lamp away from the loosened plate.
7. Slide the loosened plate away from the lamp.
8. Roll the lamp out and pull it away.
9. Reverse the steps above to install the new lamp. DO NOT touch the glass with bare hands!
Increasing Lamp Lifespan
•
ALWAYS turn the lamp off by using the DMX controller or the product’s control panel, then wait at
least 5 minutes before switching off the product. This will keep the fans running to extract any
remaining heat from the product’s head.
•
DO NOT power cycle the product unless it is necessary.
•
DO NOT re-strike the lamp immediately after turning it off. It is recommended to wait 5 minutes
before trying to re-strike the lamp.
•
DO NOT touch the lamp without wearing gloves to avoid leaving grease on the bulb or on the
contacts that could reduce the lamp’s life.
•
ALWAYS change the lamp when it has reached its recommended lifespan to avoid the risk of lamp
explosion.
DO NOT turn the product on without a lamp!
