3
Neo Vacuum Module Manual
MODULE INSTALLATION (CONTINUED)
3. Remove the Back Panel from the Neo Head.
•
Remove any faceplates from both sides of the cart.
•
On each side of the cart, remove the screws that
fasten the back panel to the chassis, as shown.
•
Remove the handle by removing the two (2) screws
near the rear of the device from each side of the
handle.
•
Remove the back panel from the Neo Head.
4. Insert the Vacuum Module into the Cart as shown.
•
Attach the Vacuum Module with the four #2 Phillips
screws removed from the back panel in Step 2.
5. Thread the Ribbon Cable up to the receptacle on the
circuit board, plug in, and secure with locking clips, as
shown.
•
If needed, remove the cable between the power
supply and the board prior to securing the Vacuum
Module ribbon cable. Reattach the power supply
and board cables after securing the Vacuum Module
ribbon cable.
