2
Neo Stimulation Channel 1 & 2 + EMG Module Manual
Install module from the left side (when facing the screen)
of the unit.
The Neo Stimulation Channel 1 & 2 + EMG Module is
designed only for use with Vectra Neo or Intelect Neo
Therapy Systems.
Items included in the modules:
Electrotherapy Module Channels 1/2 – PN 70000
• Stimulation module
• Lead wires
• DURA-STICK® 2 in (5 cm) Round Disposable Electrodes
(1 pack of 4)
• Faceplates (to cover module after inserted)
Electrotherapy Module Channels 1/2 + sEMG – PN
70004
• Stimulation module (2 channel Stim with sEMG)
• sEMG Leadwires
• DURA-STICK® 2 in (5 cm) (2 packs of 4) Round
Disposable Electrodes
• Faceplates (to cover module after inserted)
Tools required (not included):
• #2 Phillips screwdriver
• Standard slotted screwdriver
The system is programmed to automatically recognize
the new Module, therefore, no software installation is
required.
Complete the following steps to install the module:
1. Power off device. Remove main power cord from the
rear of the device.
2. Remove the blank faceplate over the second slot from
the front on the left and right sides of the unit. Insert
a standard slotted screwdriver in the top slot, pressing
down with slight pressure. Pull the faceplate away.
3. The second slot is illustrated below, but the technique
is the same for all modules.
4. The module is inserted on the left side in the second
slot as shown. Carefully insert the module into the
slot, with 32 pins (2 x 16) in first.
5. Set the module in place with gentle pressure until you
feel an end point of travel.
MODULE INSTALLATION
