Chattanooga Group FLUIDC DHT 1480, Service Manual

Page: 17 / 49

Fluido DHT ™ Dry Heat Therapy Unit
15
REMOVAL & REPLACEMENT
FFlluuiiddoo H Heeaatteerr
A A.. TToooollss R Reeqquuiirreedd
Wet/Dry Vacuum 1/8 Allen Wrench
7/16 Wrench #1 Phillips Screwdriver
Wire Cutters Hammer
B B.. R Reem moovviinngg tthhee FFlluuiiddoo H Heeaatteerr
1. Remove lid completely from unit.
2. Using the wet/dry vacuum, remove the Cellex from
the tub.
3. Remove the seven screws from the perforated
metal at the bottom of the tub.
4. Using the wet/dry vacuum, remove the newly
exposed, excess Cellex.
N NO OTTEE:: When vacuuming, be careful not to
damage the temperature sensor.
5. Remove the rubber tub insert closest to the control
panel. Then, remove the other rubber tub insert.
6. Using the wet/dry vacuum, remove the newly
exposed, excess Cellex.
7. Remove the ten hex screws from the bottom of the
tub.
!
CAUTION
Make certain to vacuum the screw heads at the base of
the tub. This will ensure that Cellex will not fall in the
standoff’s holes, and you will not round out the heads of
the screws when re-inserting them.
!
CAUTION
Make sure to remove the excess Cellex from the heads of
the hex screws to avoid rounding out the heads of the
screws.