Charnwood W618, Operating Instructions Manual

Page: 10 / 20

- Place an M6 x 30mm domed pozi head screw and washer in the 3 holes in the front
and rear of the main table. Attatch an M6 square nut to each. Slide the extruded support
arms onto the nuts so that the nut sits in the T-slot (Fig.26, 27, 28, 29).
- The extension table is supplied with several M6 shim washers to allow you to set the
height level with the main table (Fig.30). Place an M6 x 15mm domed pozi screw with
washer into each of the 6 holes on the extension table lip. Put the required number of
shim washers onto the screws and hold in place using an M6 nut. Screw the nut on so
there is a 2mm gap between the nut and shim washers (Fig.31).
- Slide the extension table
into place sliding the M6 nut
into the support arms T-slot
making sure the shim
washers are on top of the
extrusion. Slide all 6 nuts
and screws into place and
tighten (Fig.32 & 33).
Fig.26 Fig.28
Fig.27 Fig.29
Fig.30 Fig.31
Fig.32 Fig.33