7
- There are 6 different lockable positions. Press the locking lever and turn the block until
it is in the correct position
- Loosen the seven blade screws (part#74)
- Remove the blade from the cutter block taking note of the direction the blade is facing
to ensure it is replaced the same way
- Place the new blade into the cutter block seating it on the two springs (part#75) and
making sure it is positioned centrally
- Sit the blade setting device onto the cutter block and press down so the blade is set to
the correct height
- Whilst holding down the blade setting device tighten up the seven blade screws
- Carry out the above steps for the second blade
- Once both blades are fitted slide the dustproof cover back over the cutter block and
refit the extraction port
Replacing the motors carbon brushes
- When the carbon brushes get below 4mm they will need to be replaced. Follow the
instructions below to check the brushes regularly and replace when necessary
- There are two brush covers (part#159) one is situated at the front of the machine and
the other is located from the rear with the cutter wound down to the bottom to give easy
access
- Using a flat screwdriver remove the brush cover, slide out the old brush and replace if
necessary
-
Refit the brush cover
