Charnwood Cove 1, Operating & Installation Instructions Manual

Page: 11 / 20

Fig.6. Vertical register plate with bricked up fireplace
Fig. 7. Horizontal register plate with rear flue connection
Fig. 8. Horizontal register plate with top flue connection
Fig. 9. Horizontal register plate with optional vertical rear flue connector
2. Store stand
Place the Store Stand on the hearth, with at least 100mm clear space
behind it. Remove the lower cover as described above - it is not used.
With 2 people, carefully lift the stove on to the stand such that the
front end of the Air Control Rod is lowered down inside the stand.
Take care not to bend or damage the Air Control Rod. Temporarily
rest the stove on the stand in this position and pull the Air Control
Rod through the hole in the front of the stand. Now move the stove
towards you to align the slots in the side of the stand with the 6mm
tapped holes in the base brackets. Fix in position with the bolts that
were used to secure the cover and replace the Air Control Knob.
PRE LIGHTING CHECK
Before initial lighting the following points should be checked:
1. The bottom grate bars must all be fitted and should move freely
and easily when the riddling mechanism is operated.
2. The plates round the sides and back of the grate must be in
position and sitting correctly.
3. The throat plate must be fitted in the roof of the appliance and
should be checked to ensure that it has not become dislodged in
transit. The method of location and positioning of the throat plate is
shown in Fig. 4.
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Alternative
Soot Door
Positions
Register Plate
With Soot Door
Register Plate
Soot Door
in side or rear
of Chimney
®
charnwood
INSTALLATION INSTRUCTIONS
11