5
Assembling The Bandsaw
Pull the table extension out so you can
slot the table into place on the trunnion.
Line up the four threaded holes in line
with the holes in the upper trunnion.
Use the four bolts attach the table to the
trunnion, leaving the bolts slightly loose.
Carefully place a steel rule against the
side of the blade, in the gap between 2
of the teeth.
Set the table parallel to the blade.
Twist the table on the trunnion until the
rule is aligned with the table slot.
Fully tighten the four bolts holding the
table to the trunnion.
Screw four wing bolts with washers, 2
turns into the tapped holes in the
underside of the table.
Slide the rip fence carrier over the bolts.
Ensure the carrier fits firmly up against
the front edge of the table.
Any gap in this fit will result in the rip
fence will not being correctly aligned
with the blade.
