Unplug the bandsaw from the mains socket, slacken off the blade tension and open the upper
and lower housing doors. Although there are two micro-switches which will prevent the saw
from being started with a door open, disconnection is a good habit to develop.
Remove the rip fence carrier.
Lower the upper blade guide
Remove the rip fence carrier to
expose the slot in the table
Slide blade off upper and lower
wheels, bringing it out of the
machine via the slots in the rear
frame, table and the blade guard.
Reverse these steps to fit the new blade. Ensure that the teeth are at the front and pointing
down.
Position the blade between the upper and lower guide bearings. Tension the blade and adjust
the tracking as done during the initial set up. Check and adjust, if necessary, the position of the
bearings.
Summary of Contents for 5060281690036
Page 13: ...Parts List A Saw Assembly ...
