26
(9)
Clear system logs:
Click to clear all system logs;
(10)
Component place offset:
Global offset for all components in X, Y and angle,
applied only during place operation and not during vision and calibration. Used to
fine-tune component locations on the PCB. Offsets are not saved when closing
the software.
(11)
Serial number:
The lower left corner displays the hardware serial number.
Figure
12.1.
Window after “Set”, showing setting choices.
12.1. System Set
After clicking the
“system set” button and entering the code “123456”, the “system set”
window is displayed. It is used to set system parameters and perform calibrations. Some
calibrations and functions are similar to described previously in the
“Run” section.
(1)
Calibrate cameras:
Calibrates camera locations using the vision system.
