www.charltonandjenrick.co.uk
7
LT2505 (ISS 13)
SECTION TWO Introduction (user instructions)
•
The PARAGON 2016 & 16 Hi, incorporate a single gas control, which selects ignition pilot, low and high settings.
•
The appliances incorporate a safety device in the form of an Oxygen Depletion System, which constantly
monitors the oxygen in the room and will cause the fire to switch off if the oxygen level reduces.
If this
repeatedly occurs do not attempt to relight the appliance until a qualified engineer has checked it, the problem
may not be due to lack of air or a defective flue. The oxygen depletion pilot can only be changed for an identical
one from the same manufacturer with the same code number.
(THIS DEVICE MUST NOT BE OVERRIDDEN.)
•
The pilot can be left on or the pilot can be extinguished and relit each time the fire is used.
•
A fire front (fret) must be used with this appliance and must conform to the following:
•
It must be made from non-combustible material.
•
Its general construction should enable it to stand
firmly across the full width of the burner.
•
The design of the fire front (fret) must have a
removable ash tray cover (lower section).
•
The ash tray cover must have cut-outs and or holes
which provide ventilation to the underside of the
burner.
•
The effective area of ventilation through the ash tray
cover must be greater than 1365mm2 (2.12 sq. ins.)
SECTION THREE Operation (user instructions)
The appliance Control Panel is positioned behind the fret, and carries the control knob. The full lighting procedure is
as follows: -
1.
Push control knob in as far as possible on gas controls.
2.
Turn knob anti-clockwise until a click is heard. The knob will stop at the position marked
'
'
and a spark
should be seen at the tip of the ignition probe. At the same time the pilot flame should light. KEEP THE
KNOB PRESSED IN FOR 20 SECONDS. Should the pilot fail to light, turn the control knob clockwise to the
'
'
position, wait 3 minutes and repeat the procedure.
3.
After lighting the pilot flame the control knob should be allowed to spring out slightly. This will allow you to
turn the knob further anti-clockwise to the position marked
'
'
. The pilot flame should then ignite the main
fire.
4.
It is possible to adjust the height of the flames by turning the control knob between the positions marked
'
'
and
'
'
. Note that the knob 'latches' in position at either end of this movement and must be pushed in
slightly before it can be turned.
5.
To turn the fire off, depress the knob slightly and turn it to the
'
'
position.
6.
To completely extinguish the fire, depress the knob slightly and turn to the
'
'
position.
Note: - If the ignition fails the pilot can be lit with a taper or a match held at the pilot head. Remove fret for access
and replace after lighting.
If the fire has extinguished for any reason wait 3 minutes before relighting
