5
•
Place Control Panel Assembly onto Smoker Chamber by placing tabs under the front edge of the Smoker Chamber. The
Control valve must engage the burner venturi tube as shown
A
.
•
From the inside of the Smoker Chamber, Install 2 #10-24x3/8” screws through the smoker chamber and through the
Control panel Tabs as shown. Thread 1 #10-24 Keps Nut onto each screw and tighten As shown
B.
Install 2 #10-24x3/8”
screws through the control panel tabs and into the burner assembly housing. Thread 1 #10-24 Keps Nut onto each screw
and tighten securely.
Shown B
14 • 07701413
A
Qty: 4
#10-24 Keps Nut
Qty: 4
#10-24x3/8" Screw
Control
Panel Tabs
Control
Valve
B
#10-24x3/8" Screws
NOTE: Hose not shown
for clarity
Control Panel
Shown Installed
6
•
Be sure the electrode wire exits the hole UNDER the venturi tube hole. DO NOT route the wire through the same hole as
the burner venturi tube.
•
Install Ignitor Wire by pushing the round connector onto the Ignitor as shown.
07701413 • 15
Push the
Round end
of ignitor wire
onto the
Rotary Ignitor
Route wire
through
hole under the
Venturi Tube
Hole
Rotary ignitor
Control Panel
Screw Hole
Burner Assembly
Housing
Install 1 #10-24x3/8"
Screw per side
