12
13
19
Inside of cart, insert rear shield tab into left slot on upper of lower back panel.
Attach front shield tabs under front brace and attach right and
Insert left and right grease tray rails into slots
left rails under front brace with three
#8x3/8”
self-tapping screws, shown
B
.
Rear
Front
Tank heat shield
Tank heat shield
Cart lower back panel
Right rail
Left rail
Front Brace
Right rail
Left rail
#8x3/8”
self-tapping screw
Grease tray opening
beneath grease tray opening in upper back panel, shown
A
.
for clarity of illustration
Note: some parts omitted
A
B
*This side UP
Tank heat shield
Release the cap and nut from electronic ignition module. Attach electronic ignition module and heat shield to the cart right
Insert AA battery into ignition module, negative (
–
) end first. Then put on the cap, shown
B
.
ignition module. Total (2) connections, shown
C
.
module. Total (5) connections. Connect the two wires (A and B) from the switch wiring harness into the back of the electronic
Connect each of the wires from the main burner electrodes, and sideburner electrode into the back of the electronic ignition
side panel with the nut, shown
A
.
+
-
ignition module
Electronic
Heat shield
Nut
Cap
wire
NOTE: Switch terminals are larger than electrode
terminals and should only be installed in
location shown as (A), (B).
AA battery
Right side panel
A
B
C
1
2
3
(A)
(B)
4
5
