19
10
9
Inside of cart, insert rear tabs (w/o holes) of tank heat shield into slots on the bottom of upper back panel.
Attach front tabs (w/ holes) of tank heat shield under front brace using two
#8x3/8”
self-tapping screws.
Front brace
Tank heat shield
#8x3/8” self-tapping
screw
Insert tabs into slots
ignition module
Electronic
Left side panel
Nut
Cap
Connect each of the wires from main burner electrodes into the back of the Electronic Ignition Module. Total (2) connections.
Connect the two wires [(a) and (b)] from the switch wiring harness into the back of the Electronic Ignition Module. Total (2)
connections, shown
A
.
Unscrew the cap and nut from electronic ignition module. Attach electronic ignition module to the cart left side panel with the
nut, shown
B
.
Insert AA battery into electronic ignition module,
negative (—) end first.
Replace the cap,
shown
C
.
NOTE: Switch terminals are larger than electrode terminals
and should only be installed in location shown as (a), (b).
1
(a)
(b)
2
A
B
+
-
Cap
AA Battery
C
