Front brace
Tank heat shield
Left side panel
Right side panel
Upper back panel
Insert tabs into slots
#8x3/8" self-tapping
screw
Note: Some parts omitted for
clarity of illustration
Leave wires outside when attaching
tank heat shield to front brace.
10
9
Inside of cart, insert rear tabs (w/o holes) of tank heat shield into slots on the bottom of upper back panel, shown
A.
Attach front tabs (w/ holes) of tank heat shield under front brace using two
#8x3/8"
self-tapping screws, shown
B.
ignition module
Electronic
Left side panel
Nut
NOTE: Switch terminals are larger than electrode terminals
and should only be installed in location shown as (a), (b).
1
(a)
(b)
2
A
B
+
-
Cap
AA Battery
C
Connect each of the wires from main burner electrodes into the back of Electronic Ignition Module. Total (2)
connections. Connect the two wires [(a) and (b)] from switch wiring harness into the back of the Electronic
Ignition Module. Total (2)connections, shown
A
. Unscrew the cap and nut from electronic ignition module. Attach
electronic ignition module to the cart left side panel with the nut, shown
B
. Insert
AA
battery into electronic
ignition module, negative (
—
) end first. Replace the cap, shown
C
.
18
A
B
Summary of Contents for 463241013
Page 29: ...NOTES 29...
Page 30: ...NOTES 30...
