Page 11
8
7
NOTE: The temperature gauge may be packed inside of
the smokestack to prevent damage during shipping. If so,
remove gauge before assembling smokestack to chamber.
• Insert two
#10-24 X 3-1/2”
screws into handle and place
spacers and fiber washer onto screws on other side of handle.
• Place the handle assembly into the holes on the front of the
smoker chamber door and secure with two
#10-24
flange nuts.
Tighten flange nuts until bolt head is flush with handle.
• Repeat on firebox door.
• Assemble spring handle by sliding spring through handle rod
until spring is in the middle of handle rod as shown in inset.
• Insert spring handle through holes on the side of firebox and
secure with two
1/4-20
flange nuts.
Fully tighten all screws and nuts.
Screw
Handle
Spacer
Fiber
Washer
Nut
Nut
Spring
Handle
Firebox
Handle Rod
Spring
8
• Remove
wing nut
from temperature gauge.
• Insert temperature gauge though smoker chamber lid hole
above handle securing it from the underside with the
wing
nut
removed aligning the gauge settings before fully
tightening.
Temperature
Gauge
Wing
Screw
