Char-Broil 08101381-16, Product Manual

Page: 14 / 40

3
Qty: 3
#10x3/8"
Self-Tap Screw
Ignitor
Qty: 2
#6-32x3/8"
Threaded Screw
Qty: 2
#8x1/2"
Self-Tap Screw
#8x1/2"
Self-Tap Screw
#6-32x3/8"
Threaded Screw
Control Panel
Louver Side
Valve angles
to side
Hose angles
downward
Valve, Hose,
Regulator Assembly
Carefully insert valve end into
burner tube making sure valve
is centered with burner tube,
After aligned correctly, secure
with one self-tap screw on single
tab of control panel.
#10x3/8"
Self-Tap Screw
Burner Tube
Valve end
Valve and Burner
Centered
B
A
C
Electrode
Spade end
of ignitor wire
D
View is shown
with unit upside-down
• Attach rotary ignitor to control panel using two #8x1/2" self-tap screws (A).
• Attach valve to control panel
Make sure valve is inside burner tube. Secure control panel using one #10x3/8” self-tap screw through single
tab side (B).
Slide heat shield between
control panel. Secure with two #10x3/8" self-tap
screws assuring heat shield is attached using bottom screw (C).
• Attach round end of ignitor wire to rotary ignitor (A).
holding valve in correct position using two #6-32x3/8" threaded screws (A).
•
• appliance body and louver side of
• Attach spade end of wire to electrode (D).
Ignitor Wire
View is shown
with unit upside-down
#10x3/8"
Self-Tap Screws
Heat shield hole
aligned with
Bottom screw
Heat Shield slides
between Control Panel
and body and underneath
Ignitor Wire.
Hea
t shie
ld
in plac
e
Ignitor
wire
View is shown
with unit upside-down
14