7. Programming Codes
7.1
Factory Default
The factory default settings are shown with bold
< >
in the following pages.
To set the scanner parameters to factory
default
Set factory default
Reset all configuration parameters to their factory
default setting. After this reset you must select all
required parameters that meet applications.
7.1.1 Interface Selection
<Keyboard mode>
RS232 Serial Mode
<USB HID Mode>
USB Com Port Mode
16
Summary of Contents for IG-300
