Champion Rescue Tools – SUPER BEAST Multi-tool Detailed Tool Instructions
© Champion Rescue Tools
Attaching (or Changing) the Head on the SUPER BEAST
1. Remember to always the wear the appropriate
safety equipment (PPE), including gloves, as
the blades have sharp protrusions and edges.
2. Note: The tethered pins holding the
blades/arms or clevis will not come out until
cylinder is extended a minimum of 1” or 25.4
mm.
3. Turn the power unit pump control valve to the
“OFF” position.
4. Cycle the valve trigger (control) on the tool left,
then right, or right then left.
5. Place the tool on the ground or a stable surface
in a well lit area.
6. Pull the center pin by the knurled knob first.
Then remove the pins on each side of blade or
arm. Do not pull on the tethers.
7. Remove the head and place out of the work
area.
8. Make sure the head and socket are clean, with
no dirt, sand, or debris. Take the desired
head and slide over the center shaft.
9. Align center hole and insert large pin, pushing
pin all the way down.
10. Take the blades/arms and align the holes with
the link arms on the tool.
11. Insert pins as previously described.
12. Turn the “dump” valve at the power unit to
“on position”. Now the tool is ready for use.
Step 1
Step 2
Step 3
