Champion Rescue Tools – SUPER BEAST Multi-tool Detailed Tool Instructions
© Champion Rescue Tools
Introduction
Thank you for purchasing the SUPER BEAST Multi-tool –
the safest, most powerful and functional rescue tool in
the market. For General Operating and Safety
Instructions please refer to the “General Operating
Procedures” Booklet furnished with your tool.
General Safety and Operating Instructions
1.
Always turn the power unit to the “off” position and
place the control valve in the “off” position for any
service or clearing work. You should also “dump”
the valve by pushing it all the way to one side and
then the other – this releases any stored energy and
eliminates tool creep.
2.
Familiarize yourself with the tool(s) and control
valve, moving the control valve back and forth until
familiar with the valve action and operation. NEVER
put any part of your body between the moving parts
of this or any other tool!
3.
The SUPER BEAST will cut a broad range of
materials. Inspect the cutter blades after each use
to make sure it is in good condition. Inspection of
the blades before each use is a MUST! If blades are
suspect in any way, pull the tool out of service
immediately and replace the blades. Remember
you are cutting with many thousands of pounds of
force.
4.
Worn edges can be filed, but NEVER grind them
with a hand grinder. To file the blades simply lay a
file on the inside, or ground side, of the blade being
careful to NOT just file the edge. File at least 2 to 3
inches of the blade at a time so as to keep the blade
edge flat and do not roll it over. If rolled, the blade
will be ruined. If this happens, the blade will have
to be returned to the factory for repair or
replacement. Note: Do not file the blades regularly
as maintenance – only file if the blade is damaged.
5.
If your spreader tips get worn or have dings and
dents you may also file those as needed.
6.
The Hydraulic Cylinder on your new tool operates
under extreme pressure and is a sealed unit. Under
normal use, it does not require service. The factory
sealed cylinder must
NEVER
be taken apart. Doing
so will void your warranty and could potentially
result in severe injure or even death.
7.
As long as the cylinder remains sealed and is not
tampered with, any defect or malfunctions are
covered by the Champion limited lifetime warranty
(to the original purchaser). See the “Champion
Rescue Tools Statement of Lifetime warranty” for
additional information.
8.
The control valve must be kept clean. Blow off sand
and dirt with an air hose. Use WD-40- on the valve
spring. Valve does not need any maintenance.
9.
Make sure the tethered pins or ball detents that
hold the head clevis and arms/blades in place stay
adjusted so the pins do not work loose.
10.
As with all Champion Rescue Tools, the operating
speed can be slowed down or increased by moving
the trigger accordingly. If the trigger is opened
partial the movement will be slow; If the trigger is
opened all the way movement will be faster.
Always use proper safety gear and follow all safety
instruction
as
outlined
in
this
manual
Operating Pressure
10,500 psi
Weight (Cutter)
51.9 lbs
Weight (Spreader)
45.0 lbs
Length
28 – 34 inches
Width
12.5 inches
Height
8 inches
Blade Opening
10.75 inches
Max Cutting Force
500,000 lbs
Spreader Opening
28 inches
Max Spreading Force
140,000 lbs
Hydraulic Fluid Type
Specified by Customer
