Champion Rescue Tools – RC-5 Guillotine Cutter Detailed Tool Instructions
© Champion Rescue Tools
Blade Changing Instructions
1.
Extend blade approximately 2 – 2.5 inches or until
cap head screws are exposed.
2.
Turn off pump.
3.
Move thumb control (valve) back and forth a few
times to neutralize pressure.
4.
Disconnect the cutter from power source.
5.
Use Allen wrench to back out cap head screws
completely and discard head screws.
6.
Slide old blade out of track through the slot in the
head of the tool (use mallet if necessary).
7.
Slide new blade through slot in the head into the
slot in the rod.
8.
Seat blade completely into rod and align screw
holes.
9.
Insert new cap head screws into large holes in rod
(countersunk side not the threaded side) CAUTION:
start by hand the first few times.
10.
With the Allen wrench, screw cap head screws
through the blade and into the threaded part of the
rod.
11.
Tighten cap head screws until snug.
12.
Be sure cap head screw heads are even or slightly
below the surface of the rod.
13.
Check the threaded side to insure that the cap head
screws do not protrude pas the surface of the rod.
14.
Reconnect the cutter to the power source.
15.
Turn power on.
16.
Retract rod with the new blade attached to the rear
position.
17.
The cutter is now ready to use.
Maintenance Instructions
1.
Inspect the tool head and the overall tool after
every use for wear and damage. Never use a
damaged tool.
2.
Remove any debris from the tool or heads.
3.
Keep the tool clean and dry. Wipe with a clean
cloth if necessary. Use a mild detergent to clean the
tool and dry thoroughly.
4.
Lubricate the valve spring with a light lubricant, such
as WD-40.
5.
Ensure the handle is tight.
6.
Inspect couplers to ensure that they operated
correctly and are free of dirt and debris. Blow out
with an air hose if needed.
7.
Inspect hoses for cracks, cuts and bulges. DO NOT
operate tools with damaged hoses.
8.
Inspect cutting blade for wear or damage. DO NOT
operate with damaged blades.
9.
Keep tool free from rust and corrosion.
10.
Replace handle if broken or damaged.
11.
Replace Missing or damaged decals, if needed.
